Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion Bennettt 966

Anybody have any pictures of the insides, trying to figure out how or what meter went into this. Have four meters and do not know how it fits in.
Thanks Craig

Craig these are for a 600 series Bennett, if I recall correctly; same as 900 series.

Yes great pictures, just what I needed to know.
THANKS

Glad you found what you were looking for.

Of course I do not have the measurements for the large spacer. I also need a hinge if some one has it for one of the doors. Two of the metal pieces that would go on the inside of the door for the ad glass also. There must be some little clip that holds the front stainless on that goes through the rubber if anyone knows about this.
Thanks

some went on the channel in the rubber, some used a flat piece of metal that goes inside the trim with a small nail in the center of the flat metal to push into the rubber.

Small nail is the one I have, but what to nail to?

Unrelated question: what's the device on the left side of the computer as you face the totalizer? It has a small shaft connected to it from the computer, opposite of the reset crank. Looks like I'm missing it. What does it do?

I do not know, was wondering that myself. Where is DB when you need him?

Craig, I'll have to measure the spacer for you. The small nails from the clip that attach stainless window trim go into the rubber seal that holds the window in place.

That other piece you are inquiring about is the mechanism that activates the switch for the electric pump motor once the pump has been reset.

I don't collect or have any 40's-50's pumps [except for 3 Nat. 991/Tok. 99 Lu-Bars].
I'll buy 'em, gut 'em & sell 'em.

But you have the Knowledge and ability to find out the facts.

I think it is some kind of interlock device. Whatever it is I have a couple.

Hi Keithia. I sent you a PM about the interlock device.