|
#321267
Tue Apr 24 2012 07:46 AM
|
Joined: Mar 2012
Posts: 171
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Mar 2012
Posts: 171 |
Hello everyone. I was wondering if anyone can explain to me how to install the add glass and panel glass on my pump. Also, do I need to cut the rubber moulding at each corner or is the moulding one continuos piece?
Thanks
Marvin
|
|
|
Please - NO offers to Buy or Sell in this forum category
Statements such as, "I'm thinking about selling this." are considered an offer to sell.
|
|
|
Joined: Nov 2002
Posts: 4,962 Likes: 17
Moderator
|
Moderator
Joined: Nov 2002
Posts: 4,962 Likes: 17 |
It is one continuous piece of rubber gasket.
To install it, use a small string, insert the string in the groove of the rubber, then pull the string out pushing on the glass and it will roll the rubber over the edge of the glass.
Use plenty of soapy water or something else for lubricant. I use glass cleaner.
FREEDOM oil items wanted.
|
|
|
|
Joined: Apr 2011
Posts: 83
Active Member
|
Active Member
Joined: Apr 2011
Posts: 83 |
This is what I did, I used one continuos piece of rubber but cut the corners of the inside channel off(where the glass sits). Hope this helps
|
|
|
|
Joined: Jun 2011
Posts: 39
Active Member
|
Active Member
Joined: Jun 2011
Posts: 39 |
AntG, did you use the string method like ryan suggested?? Or did you put the rubber on the door first then install the glass?? I'm really having a hard time getting mine installed!
|
|
|
|
Joined: Dec 2011
Posts: 8,818 Likes: 2
Veteran Member
|
Veteran Member
Joined: Dec 2011
Posts: 8,818 Likes: 2 |
Put the rubber seal on the door first. Use WD40 as a lubricant and slip one edge of the ad glass into the groove (in rubber seal) and work the remaining edge of rubber seal over the edge of the ad glass.
Dave GILL, Dave's Garage & Memorabilia, Inc.
|
|
|
|
|
|