|
#685182
Fri Apr 21 2017 10:50 AM
|
Joined: Jun 2013
Posts: 791 Likes: 5
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Jun 2013
Posts: 791 Likes: 5 |
The Butler 61 I am restoring had the original curved section conduit pipe and tail section conduit pipe, but there were no brackets inside the frame to secure it. The conduit pipe was hanging from the bonnet when I got the pump. I have some homemade brackets made and ready to install.
Does anyone have a photo of a Butler 61 without the skins that shows where the conduit brackets were located and what they look like? Joe
|
|
|
Please - NO offers to Buy or Sell in this forum category
Statements such as, "I'm thinking about selling this." are considered an offer to sell.
|
|
|
Joined: Feb 2003
Posts: 2,460 Likes: 24
Veteran Member
|
Veteran Member
Joined: Feb 2003
Posts: 2,460 Likes: 24 |
In most visible pumps, the bracket had a single bolt through the center of the conduit bracket. The bracket had curved areas at each end, done on the flat side of the steel, which was placed on either side of internal piping to secure the conduit. You had conduit on one end and piping on the other. As you tightened the bolt, it would squeeze the interior pipe holding everything in place. Very simple design. Paul www.severngaspumps.com
Last edited by gasmansgp; Fri Apr 21 2017 11:01 AM.
|
|
|
|
Joined: Nov 2002
Posts: 4,962 Likes: 17
Moderator
|
Moderator
Joined: Nov 2002
Posts: 4,962 Likes: 17 |
In most visible pumps, the bracket had a single bolt through the center of the conduit bracket. The bracket had curved areas at each end, done on the flat side of the steel, which was placed on either side of internal piping to secure the conduit. You had conduit on one end and piping on the other. As you tightened the bolt, it would squeeze the interior pipe holding everything in place. Very simple design. Paul www.severngaspumps.com On the pumps I have had the skins off of, the bracket looks just like described above. I dont currently have one with the skins off or I would snap you a picture.
FREEDOM oil items wanted.
|
|
|
|
Joined: Jun 2013
Posts: 791 Likes: 5
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Jun 2013
Posts: 791 Likes: 5 |
That is exactly the type of brackets I am going to use. I am not certain where the original brackets were installed, but I will figure out where and how many it takes to keep the conduit in the correct position.
It does not look like there was any type of bracket inside the bonnet to hold the junction box/light fixtures in place. I assume that the brackets inside the frame keep the pipe and junction box/light fixtures in place. Is that right? Joe
|
|
|
|
|
|