Oldgas.com Home

erie model #748 - 14

Posted By: vintagecar

erie model #748 - 14 - Sun Nov 15 2009 03:53 PM

The model number on the erie pump I just got is 748 14. how do you get the computer to turn? I have soaked it wd40 and penetrating oil. I turn back and forth on the handle and it moves the numbers a little. I didn;t know if there was something special that needed to be done to turn the numbers.
Posted By: gasoildude

Re: erie model #748 - 14 - Sun Nov 15 2009 03:59 PM

Check to see if something is in the gears. Sticks dirt wasps nests & anything else could be causing them not to turn. If all is clear keep on soaking with WD-40 or a good rust penetrating spray.
Posted By: Dick Bennett

Re: erie model #748 - 14 - Sun Nov 15 2009 04:13 PM

I assume you are trying to turn the reset handle, Have you tried turning the shaft on bottom of VR ?
Posted By: vintage_car

Re: erie model #748 - 14 - Sun Nov 15 2009 06:27 PM

no I haven't tried turning that shaft. Will give that a whirl. all gears are clean and clear of debris.
Posted By: jkyocom

Re: erie model #748 - 14 - Sun Nov 15 2009 06:33 PM

Pull it out and send it to me
$150.00 for a normal rebuild
I have 5 in stock now

I will do more than get it to turn.

....check the lockout mech on opposite side of reset
Posted By: hillsideshortleg

Re: erie model #748 - 14 - Sun Nov 15 2009 06:52 PM

jkyocom
Thats so cool seeing a computer come back to life. You make it look like new, there's a lot parts in there. Do you do watches and clocks?
Posted By: jkyocom

Re: erie model #748 - 14 - Sun Nov 15 2009 07:14 PM

just gas pump clocks
Posted By: philmccauley

Re: erie model #748 - 14 - Sun Nov 15 2009 10:45 PM

As some one stated, check the locking mechanism, if that does not work, take the totalizer off then try it. This has worked for me several times.
© 2018 Primarily Petroliana Shop Talk