Bought this Tokheim for 100. How do I get the front silver cover on? When it is on and the front panel is on there is a gap. Do I need a rubber spacer? I know I need to get a lock to keep front panel in place, just don't know about the gap and getting the Tokheim trim piece to stay in place. Any feed back is greatly appreciated.

Also, the side plate says it is a model 446A-PEH, what does that mean?

IF the studs are missing on back of TOKHEIM strip, you might have to Silicone in place for it to stay attached.

I believe that if you look closely at the ID tag it does not say 446, it is probably 448.

Literature on this pump can be found at:

http://www.petrolianacollectibles.com/tokheim%20448-452%20series.htm

If you have never been to my website, start at the beginning:

www.petrocollect.ocm

Over 5000 images devoted to this hobby.

Email me if interested in anything at: jhsim@swbell.net

Jack Sim

I relooked and it is a 448 as you suggested. The numbers are very faint. What about the gap between the top and bottem panel?