WTB Erie/Neptune 10" Clockface Mech - Thu Sep 26 2019 01:44 PM
Looking for 10" Erie Clockface mechs and brass Neptune flowmeters that goes below the mech. The 10" Mechs
are use on the Erie 753, 603, 450, etc. Would also consider extremely rough complete or parts pumps.
These mechs I think might have been used by some other companies in their pumps. Would be interested
in just the brass Neptune flow meters if that is all you have. Anyone restoring an Erie and not keeping
the pump guts below the mech or have some guts, I would be interested in buying.
I heard a guy at the last Columbus show had one on his tailgate near Randy Ross if anyone knows who that was?
If you know of anyone that might have a lot of parts or partial pumps I should contact, any info would be great!!
Thanks
Eric
317 502-5669
evong@vanausdall.com
are use on the Erie 753, 603, 450, etc. Would also consider extremely rough complete or parts pumps.
These mechs I think might have been used by some other companies in their pumps. Would be interested
in just the brass Neptune flow meters if that is all you have. Anyone restoring an Erie and not keeping
the pump guts below the mech or have some guts, I would be interested in buying.
I heard a guy at the last Columbus show had one on his tailgate near Randy Ross if anyone knows who that was?
If you know of anyone that might have a lot of parts or partial pumps I should contact, any info would be great!!
Thanks
Eric
317 502-5669
evong@vanausdall.com