Anyone have a reset crank shaft for the M&S 80 for sale? I have the reset handle and only need the reset crank shaft.
Thanks,
Mike Hudson (303) 916-3907
You can make one very easily if you pick up a piece of solid rod at the hardware. Thread one end 5/16" and cut to length. A small rolled pin works to crank the computer. Very quick and nearly painless.
Thanks for the information and will try to do this on my own unless someone has one available off an old scrap pump.
Thanks,
Mike
Do you know the length?....pin to pin?
When I get the reset handle tomorrow I will find out the length and let you know.
Thanks!
I have two 6 3/8" center of pin to center of pin. They are rust pitted bad. I may have others.