Oldgas.com Home
Posted By: Mikegoe Penno Tin Sign - Mon Aug 14 2017 11:05 PM
Any ideas of value of this Penno tin. It's about 16"-18" diameter. Thanks

Attached picture IMG_1652.JPG
Posted By: puregas Re: Penno Tin Sign - Tue Aug 15 2017 02:00 AM
I'm sure I'm wrong, but that almost looks like a rocker can side but it would be awfully hard to cut out. Is it possible that could be a side of one before rocker was made? Are there any mounting holes?
Pat
Posted By: Mikegoe Re: Penno Tin Sign - Tue Aug 15 2017 10:30 AM
There are no mounting holes and it is much thinner metal than a rocker can has. I'm not sure how or where this sign would have been mounted. It is embossed a little bit like maybe two were put together in s lollipop stand?
Posted By: low on oil Re: Penno Tin Sign - Tue Aug 15 2017 10:40 PM
Definitely looks like the side of a rocker can not sure the exact process but if it's thin and flimsy it would stiffen up after being pressed together to make the can?
Posted By: BryceG Re: Penno Tin Sign - Wed Aug 16 2017 02:05 PM
with that diameter... i would guess it to be a tire insert. definitely not a rocker can. Penno rockers dont have a yellow border like that
Posted By: BryceG Re: Penno Tin Sign - Wed Aug 16 2017 02:07 PM
as for value... I'd guess $75-125
Posted By: advertologist Re: Penno Tin Sign - Wed Aug 16 2017 03:24 PM
when I first seen this post the first thing that came too mind was, cut out of a rocker can? .. ... cool
value- condition: minimal
© Primarily Petroliana Shop Talk