I've been kind of looking for one of these for 18 years. Always seemed to miss them. A friend picked this one up off Ebay for $1500 a couple of months ago and was kind enough to pass it on to me (for a small profit of course) Thanks Mike!
Anyone know what kind of nozzle this takes, gone through about 30 that I have and none fit quite right.

GOOD JOB ON THE PUMP. THAT IS A. NICE ONE. TOM

Casting above face reminds me of a Bi-wing plane. Not a real common pump.

I've had the Top 3/4 of one & 1 side skin for quite a few years. Been looking for a base &/or a parts pump so I could finish it.

IF you remove the Top Casting it is made to hold a Globe, page 190 top center pump in Da Book. Your Base is slightly different than one in book.

Might have been an extra piece threaded on hose then nozzle threaded on to that, similar to an early G&B winged nozzle.

Nice pump!!!
I like it!
Rob

Can anyone confirm that pump has the correct Visi?
I have one like it & was told it was/is for a HAYES.

I think the visi is correct, there was another 65 on here last year that had the same one and I think the one Bill A. had in Tacoma was the same too.

That pump is cool. I wanted it. I sent the guy a meassage asking some questions and for more pictures. got no response and auction was ended.

Real nice.