Hey Guys, Trying to get some parts together for some projects this winter. These corners are off of a National Apex pump. They're 63" tall...unfortunately just a few inches taller than a Bennett 76. Anyone have any of these laying around? I need two for me but a buddy needs all four. Anything you have would be great. And as always, leads are VERY APPRECIATED!
Ron Scobie makes the 76 trim so I bet he could get some longer pieces made for you if it is the same profile. He might even have some already made for that pump although it's not listed in the Apex parts in his catalog.You could also take the plain steel ones for a 76 that he does have and buy an extra and lengthen them for your pumps. You'd have to have them plated or paint them though if you can't get the stainless ones made to the exact length you need........GB
Last edited by Rabbitman; Mon Sep 14 201503:13 PM.
All very good advice. I've talked with Ron and he's made them in the past but doesn't get enough call for them to make a run at this time. He may be able to help me out in the future, which I appreciate, but I was just hoping someone might have a couple tucked away