|
#712337
Sat Jun 30 2018 08:02 AM
|
Joined: Oct 2001
Posts: 1,346 Likes: 17
Veteran Member
|
OP
Veteran Member
Joined: Oct 2001
Posts: 1,346 Likes: 17 |
.This is a question for the visible pros...I have a WAYNE 517 (original brass tag says 517)..The distance from the center of the hole where the handle stem comes out to the tab on the skin to lock it is 11.5"...The handle that came with it is a cast-iron handle and the measurement from the center where it attaches to the locking tab is 16"...This is the wrong handle I guess.....Here is my question..If I order a aluminum handle from VIc's or GPH, for a WAYNE 515, will it fit my pump???. I know I will have to make a square hold in the handle and I can do that...Any comments..Thanks Warren
|
|
|
Please - NO offers to Buy or Sell in this forum category
Statements such as, "I'm thinking about selling this." are considered an offer to sell.
|
|
|
Joined: May 2006
Posts: 316
Petro Enthusiast
|
Petro Enthusiast
Joined: May 2006
Posts: 316 |
Warren, I just measured an original cast iron 515 handle and from the center of the shaft hole to the center of the locking tab it measures 12 1/4"
|
|
|
|
Joined: May 2006
Posts: 316
Petro Enthusiast
|
Petro Enthusiast
Joined: May 2006
Posts: 316 |
Warren, on a hunch I measured my 515 with a stamped steel handle and it measures 11.5" from the center of the shaft to the locking tab. I'm guessing that it may have had a stamped handle and not a cast one. I know Kevin Firth had some extra stamped handles a while back that may fit
Jerry
|
|
|
|
Joined: Oct 2001
Posts: 1,346 Likes: 17
Veteran Member
|
OP
Veteran Member
Joined: Oct 2001
Posts: 1,346 Likes: 17 |
Jerry,,,,Thanks man....I will get hold of Kevin...Warren
|
|
|
|
|
|