|
#324682
Wed May 09 2012 08:23 AM
|
Joined: Mar 2012
Posts: 171
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Mar 2012
Posts: 171 |
Hello Everyone. I was looking for some assistance. Do any of you have any ideas what I could use to finish off the pull lever that is attached to my electrical manifold? I have been to Home Depot with the idea to use a drawer pull knob, but there openings on the back where to small for the lever to fit. If I had to I might be able to drill the hole out wider so it will fit. But before I do that I was looking for ideas from you. I am not aware of any place that sells the original or reproduction part. If you can come up with some other ideas I would appreciate it.
Thanks
Marvin
|
|
|
Please - NO offers to Buy or Sell in this forum category
Statements such as, "I'm thinking about selling this." are considered an offer to sell.
|
|
|
Joined: Mar 2011
Posts: 595
Petro Enthusiast
|
Petro Enthusiast
Joined: Mar 2011
Posts: 595 |
if you have a Hobby Lobby near you they have all kinds of round wooden things for crafting....then just drill the right size hole. I've done it several times. If no Hobby Lobby ask your wife where the largest crafting store is at...
|
|
|
|
Joined: Dec 2011
Posts: 8,818 Likes: 2
Veteran Member
|
Veteran Member
Joined: Dec 2011
Posts: 8,818 Likes: 2 |
Marvin, in the past I have used the pull knob from a vanity sink drain plug. I am referring to the pull rod that is located in the middle of the faucet to open and close the drain. They are nicely chromed and come attached to an approx 8" long rod.
Dave GILL, Dave's Garage & Memorabilia, Inc.
|
|
|
|
Joined: Mar 2004
Posts: 149
Petro Enthusiast
|
Petro Enthusiast
Joined: Mar 2004
Posts: 149 |
This is the pull,no knob. If you want one with a knob I think I have one in the shed that you are welcone to.I'll ck tomorrow and let you know. Bill
|
|
|
|
Joined: Mar 2012
Posts: 171
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Mar 2012
Posts: 171 |
Bill. If you have one that would be great. Thanks for looking!
Marvin
|
|
|
|
Joined: Mar 2004
Posts: 149
Petro Enthusiast
|
Petro Enthusiast
Joined: Mar 2004
Posts: 149 |
Marvin This will work just like the other one just use a 1/4 lock nut instead of cotter pins.PM me your address and I'll drop it in the mail on sat. Bill
|
|
|
|
|
|