|
|
#590846
Wed Jan 07 2015 08:06 AM
|
Joined: Dec 2010
Posts: 1,151 Likes: 41
Veteran Member
|
OP
Veteran Member
Joined: Dec 2010
Posts: 1,151 Likes: 41 |
Can anybody give me the approximate/average height of most visible pumps like say the G&B176, Hayes, Fry, etc. with globe. I don't need anything exact but am trying to figure out whether or not to put the ceiling , or part of it, in my new addition high enough to accommodate a few visibles down the road and I don't have one handy to measure. I was thinking you need about a ten foot ceiling to have room for most of them, am I close? Thanks.....GB
|
|
|
Please - NO offers to Buy or Sell in this forum category
Statements such as, "I'm thinking about selling this." are considered an offer to sell.
|
|
|
|
Joined: Jun 2011
Posts: 358 Likes: 3
Petro Enthusiast
|
|
Petro Enthusiast
Joined: Jun 2011
Posts: 358 Likes: 3 |
My garage has 13 foot ceilings and has about 3 inches between the top of my TALL ten visibles with globe and the ceiling. If I was to build one I would go 13 feet. Unless you find a 15 gallon pump!!!
|
|
|
|
|
Joined: Nov 2002
Posts: 4,956 Likes: 9
Moderator
|
|
Moderator
Joined: Nov 2002
Posts: 4,956 Likes: 9 |
I have a 12 foot ceiling in my office. I have an Ottawa in my office with a 15 inch globe on it. There is about 16-20 inches of room from the top of the globe to the ceiling.
FREEDOM oil items wanted.
|
|
|
|
|
Joined: Aug 2011
Posts: 1,705
Veteran Member
|
|
Veteran Member
Joined: Aug 2011
Posts: 1,705 |
That will put your globe close to the ceiling on a Fry 117. I have 10.5' ceilings and have a little room with the pump on the floor w/o a wooden base. Dave
Dave Jones
It's All Just Stuff
|
|
|
|
|
Joined: Dec 2010
Posts: 1,151 Likes: 41
Veteran Member
|
|
OP
Veteran Member
Joined: Dec 2010
Posts: 1,151 Likes: 41 |
That's what I was afraid of. I think I'm going to have to just display any visibles out in the main shop area where I've got a 16' ceiling. I'm building the display room inside the shop so that I can gain some storage floor space above it. If I go any higher than 9' it is going to make it hard to utilize the upstairs area. Thanks for the input everyone....GB
|
|
|
|
|
Joined: Sep 2014
Posts: 64
Active Member
|
|
Active Member
Joined: Sep 2014
Posts: 64 |
I have a G&B176 with a 15 Inch globe, it's roughly 11 1/2' Feet tall with the globe.
Collecting Tiger Products by Gambles Store.
Montana ~
|
|
|
|
|
Joined: Dec 2012
Posts: 374 Likes: 24
Petro Enthusiast
|
|
Petro Enthusiast
Joined: Dec 2012
Posts: 374 Likes: 24 |
My ceiling height is 11'6" and houses a Wayne 615 with a Red Crown globe. I have at least a foot to spare and it is all sitting on castors 6" off the floor.
Randy
|
|
|
|
|
Joined: Dec 2011
Posts: 1,391 Likes: 4
Veteran Member
|
|
Veteran Member
Joined: Dec 2011
Posts: 1,391 Likes: 4 |
Gary , I just measured my GB 179 with a 13" globe . It is exactly 10' 3" .
I like SINCLAIR and old American made stuff ... No china items.
|
|
|
|
|
Joined: Jan 2011
Posts: 2,085 Likes: 8
Veteran Member
|
|
Veteran Member
Joined: Jan 2011
Posts: 2,085 Likes: 8 |
Fry 17 tall cast iron base is 8'6" without Globe height. I have a 10'8" ceiling and can use both 13" and 15" globe.
*Wanted Pierce Pennant Petroleum*
|
|
|
|
|
Joined: Sep 2012
Posts: 143
Petro Enthusiast
|
|
Petro Enthusiast
Joined: Sep 2012
Posts: 143 |
As a general rule, I allow 10ft for pump and 12ft with globe
Last edited by Gasoline George; Wed Jan 07 2015 07:26 PM.
|
|
|
|
|
|
|
