|
#126357
Thu May 29 2008 06:56 AM
|
Joined: Nov 2007
Posts: 503
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Nov 2007
Posts: 503 |
Anyone have a reset crank shaft for the M&S 80 for sale? I have the reset handle and only need the reset crank shaft. Thanks, Mike Hudson (303) 916-3907
Mike Hudson 303-916-3907
|
|
|
#126358
Thu May 29 2008 03:04 PM
|
Joined: Feb 2003
Posts: 2,457 Likes: 24
Veteran Member
|
Veteran Member
Joined: Feb 2003
Posts: 2,457 Likes: 24 |
You can make one very easily if you pick up a piece of solid rod at the hardware. Thread one end 5/16" and cut to length. A small rolled pin works to crank the computer. Very quick and nearly painless.
|
|
|
#126359
Thu May 29 2008 06:20 PM
|
Joined: Nov 2007
Posts: 503
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Nov 2007
Posts: 503 |
Thanks for the information and will try to do this on my own unless someone has one available off an old scrap pump. Thanks, Mike
Mike Hudson 303-916-3907
|
|
|
#126360
Fri May 30 2008 02:25 PM
|
Joined: Dec 2006
Posts: 3,369 Likes: 7
Veteran Member
|
Veteran Member
Joined: Dec 2006
Posts: 3,369 Likes: 7 |
Do you know the length?....pin to pin?
Veeder Root Rebuilds.....since 1987 Veeder Root Identification CD Gas Pump Clock Repair jkyocom@bellsouth.net
|
|
|
#126361
Fri May 30 2008 04:45 PM
|
Joined: Nov 2007
Posts: 503
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Nov 2007
Posts: 503 |
When I get the reset handle tomorrow I will find out the length and let you know. Thanks!
Mike Hudson 303-916-3907
|
|
|
#126362
Fri May 30 2008 05:29 PM
|
Joined: Dec 2006
Posts: 3,369 Likes: 7
Veteran Member
|
Veteran Member
Joined: Dec 2006
Posts: 3,369 Likes: 7 |
I have two 6 3/8" center of pin to center of pin. They are rust pitted bad. I may have others.
Veeder Root Rebuilds.....since 1987 Veeder Root Identification CD Gas Pump Clock Repair jkyocom@bellsouth.net
|
|
|
|
|
|