Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion Roll Pin for crank mechanism

I am restoring a M&S80 gas pump. The roll pin that holds the "eyebrow" mechanism cam to the shaft is sheared. The pin measures 7/64. I have been unable to find that size roll pin locally or on the internet. Any suggestions on a source for this pin will be appreciated.
Al

Others may have sources to offer for the exact item, though if it were me (authenticity has it's limits on these old pumps), I would use a 1/8" and use a file/emery/small rotary to remove 1/64" of material. That's not too much material even for a hardened pin. Enlarging the holes to an 1/8" pin size is also another option.

[This message has been edited by pops9 (edited 05-03-2001).]

Brian-Thanks for the reply. If I cannot find the original size roll pin that is what I will do.
Al