Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion A-38 spinner drive.....copy at will

I came up with this for my brothers pump...
That was my first computer rebuild....
thanks Joe



[This message has been edited by jkyocom (edited 01-06-2007).]

[This message has been edited by jkyocom (edited 01-06-2007).]

Thats a great Idea!

J, will you be making kits of these as well ?

No...but I have spare gears.
an old speedo cable will work & 1/4 compression coupling can be adapted to fit all shafts I think. I had to knurl the spinner shaft to hold gear in place.
You may have to cut coupling in half according to clearance and silver solder the cable inside the cut end of the coupling, On Some of the older computers the shaft protrudes from the top with a collar on top. remove collar and use compression end of coupling on it.you can file or grind the Top plate where shaft comes out to get a little more clearance.Mark Sconyers makes a motor drive kit for the computer.

here are a couple I came up with quick.
Totalizer gears....use pin in horizontal gear
collar on other side to keep gear from wandering.... uses shaft as hanger for device
Same device ...one apart for better view.