Oldgas.com Home

Home | Help | Events | Books | Pictures | Auctions | Links | Collectors | Parts | Contact

Topic Options
Rate This Topic
#174062 - Mon Feb 08 2010 10:30 AM Gilbarco 96C HELP
eric wolf Offline
Active Member

Registered: Fri Apr 11 2003
Loc: new westminster, bc, canada
I am putting together my Gilbarco 96C and seem to missing some parts, does anyone have pictures or info on how the site glass manifold assembly is mounted to the frame?
How abour the reset crank?
Thanks, Eric.


Edited by eric wolf (Mon Feb 08 2010 11:39 AM)

Top
#174080 - Mon Feb 08 2010 01:59 PM Re: Gilbarco 96C HELP [Re: eric wolf]
Ryan Underthun Offline
Moderator

Registered: Thu Nov 07 2002
Loc: Duluth, MN U.S.A
The sight glass manifold mounts to the frame rails on the hose outlet side of the pump. There are two rubber bushings, washers, one bolt and nut per frame rail. Your pump should have a couple of tabs on the frame rails for the manifold to mount to.

The reset crank mounts to a shaft and pretty much floats between the computer, goes through a flat bar with a hole in it. Then there is a cotter key to hold it from sliding out.

Hope this helps, Ryan
_________________________
FREEDOM oil items wanted.


visit my website for original gas pumps and parts

www.thepumpdump.com

Top
#174081 - Mon Feb 08 2010 02:03 PM Re: Gilbarco 96C HELP [Re: Ryan Underthun]
Thunder II Offline
Veteran Member

Registered: Fri Jan 20 2006
Loc: On the plains of Colorado
And if you dont have the pump guts in the pump, the sight glass assembly will tilt down, from the top of the pump. I mounted mine, a bit differently because of this. I'll post some pics later.
_________________________
Anything Chevron

I'd rather be flying.....

Top
#174086 - Mon Feb 08 2010 02:47 PM Re: Gilbarco 96C HELP [Re: Thunder II]
Jack Sim Online   content
Veteran Member

Registered: Fri Nov 10 2000
Loc: St. Louis, MO, USA
Information on the 96C can be found on this page of my website:

http://www.petrolianacollectibles.com/gilbarco%2096.htm

Jack Sim
_________________________
Author, Gas Pump Identfication books 1st & 2nd Editions & Air Meter Identification books
We rebuild ECO air meters and sell parts.

Top
#174210 - Tue Feb 09 2010 08:39 AM Re: Gilbarco 96C HELP [Re: Jack Sim]
eric wolf Offline
Active Member

Registered: Fri Apr 11 2003
Loc: new westminster, bc, canada
Thanks for the help, got the manifold mounted, just need to make a plate for the rest crank.

Top


Moderator:  Oldgas, Ryan Underthun, Watchdog7 

| Check our Book Store for related resources |


Copyright 2014 Primarily Petroliana Interactive, All Rights Reserved