|
#186808
Mon May 10 2010 08:45 PM
|
Joined: Jan 2009
Posts: 5,979 Likes: 24
Veteran Member
|
OP
Veteran Member
Joined: Jan 2009
Posts: 5,979 Likes: 24 |
Looking to sell one of my Bennett station lites that have been blasted, primed, and blocked out. Has light socket and plug in still with it. What value would you think. Thanks
Craig
|
|
|
Please - NO offers to Buy or Sell in this forum category
Statements such as, "I'm thinking about selling this." are considered an offer to sell.
|
|
|
Joined: Nov 2000
Posts: 7,791 Likes: 9
Veteran Member
|
Veteran Member
Joined: Nov 2000
Posts: 7,791 Likes: 9 |
My Gas Pump ID Book says it is worth $600 in near 100% condition. Now just figure in what someone is willing to pay you for the sandblastimg & primer.
One question, where is the base?
Jack Sim
Author, 1st & 2nd editions of Gas Pump ID book, 3rd edition is now available at www.gaspumpbible.comAir Meter ID book also available
|
|
|
|
Joined: Jan 2009
Posts: 5,979 Likes: 24
Veteran Member
|
OP
Veteran Member
Joined: Jan 2009
Posts: 5,979 Likes: 24 |
Jack I do not have it, but the pole screws into something. If like my other ones, the screw base is IN the top of the pump or can be made easily. The harder piece is the tapeard base piece that hides the bottom. Thanks
Craig
|
|
|
|
Joined: Nov 2000
Posts: 7,791 Likes: 9
Veteran Member
|
Veteran Member
Joined: Nov 2000
Posts: 7,791 Likes: 9 |
This same set-up; bonnett, yoke & pipe was used on the ECO Islanders by Bennett, except the bottom of the pipe went into an adapter, it did not screw in. I believe Bennett purchased their lights from Revere.
Jack
Author, 1st & 2nd editions of Gas Pump ID book, 3rd edition is now available at www.gaspumpbible.comAir Meter ID book also available
|
|
|
|
|
|