Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion Canadiann Clearvision question

I need info on the bolt that hold the handle on. To be more specific the nut portion of it.

Looks like there is at least 2 versions , I have drawings for them, but am missing overall length, & the length of the curve or radius.

If anyone can measure this please post.

[This message has been edited by dodogas (edited 04-15-2008).]

Frank

I think that I sent you these measurements mabe I should send you a origional nut to look at. Off the top of my head I think the redius end was .57 I could measure the oal. I have been so busy with stuff latley but I do need some of these soon.

ward

[This message has been edited by ward zaharia (edited 04-15-2008).]

[This message has been edited by ward zaharia (edited 04-15-2008).]

A measurement of the length of the head is what I need (that is from where it touches against the handle to the end of it). Radius is less important, as I know the radius & it will fall into place as soon as I have tthe length.

Frank

I will get that measurement for you. I think you can get that measurement from subtracting the other measurements on the drawing I sent you but I will take it off the origional.

ward