Oldgas.com Home  
Home | Help | Events | Auctions | Parts | Contact
Previous Thread
Next Thread
Print Thread
Rush K lighting? #32861
Sun Nov 11 2001 04:10 PM
Sun Nov 11 2001 04:10 PM
Joined: Aug 2001
Posts: 50
Muscatine Iowa
Z
Zip's Offline OP
Active Member
Zip's  Offline OP
Active Member
Z
Joined: Aug 2001
Posts: 50
Muscatine Iowa
Just getting done with a rush k visible. I see were the light socket goes but how is it held in place. the original stuff was missing. does it attach to the end of the 1/2" nipple that the top swings on inside the top? There was alot of a cement type material inside which i assume just sealed things up and didn't actually do any more than that.Thnaks in advance everyone.

Please use For Sale forums to sell

Please - NO offers to Buy or Sell in this forum category

Statements such as, "I'm thinking about selling this." are considered an offer to sell.
Re: Rush K lighting? #32862
Mon Nov 12 2001 07:14 PM
Mon Nov 12 2001 07:14 PM
Joined: Oct 2000
Posts: 1,356
Clarksville, Tn. USA
G
Gary Drye Offline
Veteran Member
Gary Drye  Offline
Veteran Member
G
Joined: Oct 2000
Posts: 1,356
Clarksville, Tn. USA
Zip, I just finished a K model a few months ago and sold it, so this reply is from my poor memory. I removed the old socket and cleaned out all the hard sealing material. There should be a small screw hole in the top of the assembly. I purchased a pre-wired rubber lined light socket, available from any hardware store and inserted it into the assembly. I used a sheet metal screw and screwed it into the top hole into the light socket rubber covering to hold it firmly in place.


Moderated by  Oldgas, Ryan Underthun, Watchdog9 

Copyright © 2018 Primarily Petroliana Interactive, All Rights Reserved

Powered by UBB.threads™ PHP Forum Software 7.6.1.1
(Release build 20180111)
Page Time: 0.014s Queries: 13 (0.004s) Memory: 1.8242 MB (Peak: 1.8981 MB) Zlib disabled. Server Time: 2018-01-24 09:59:22 UTC