I am manufacturing a manual clock actuating mechanism for an 850.
If anyone can post a pic or two of the area around the drive shaft for the clock, it would help me tremendously.
I need a front(totalizer side)pic, with no skins and a pic from the side (opposite hose)showing the clock mount and space around the area that the clock drive is in to be able to fabricate a mount. It would be best if the clock is still mounted. This is the chain type reset clock.
I will share it when it's done.If everything works out it should be pretty cool.
There will be a small hole in the top skin that a KEY type crank can be installed and removed. The gear set up will only turn one way ( as the meter did)to actuate the hands .
then the reset will be able to set back to zero. This will require only two gears, and the mount....I just need to know my limitations on space.
Here is a sneek peek at what I have so far.
Do the gears look familiar?
Thanks Guys
Joe