Ryan:
Just lay the body down on a towel and then carefully set one lens on the face. See if you can drop in the mounting screws easily. If they drop in and the heads sit flat on the glass faces - you're golden.
If you can't get the screws in - then the notches aren't deep enough for a glass body.
Also make sure that the lens won't 'rock' on the body. Some lenses are a little 'flat' and won't sit all the way down around the edges on a glass body. If this is the case -
DO NOT try and install the lenses on the body. Just give it up an put them on a Capco.
If you desperately want them to go on the glass body - and the notches are not deep enough - you CAN have the notches cut deeper. Contact me for further information if this is the case.
Later . . .
Jim