Oldgas.com Home

Home | Help | Events | Classifieds | Bookstore | Pictures | Auctions | Links | Collectors | Parts | Contact

Topic Options
#502425 - Thu Jan 02 2014 10:02 PM ECO light assembly
K W FRITH Offline
Veteran Member

Registered: Sun Oct 21 2007
Loc: Devils Lake, ND---USA
Would anyone have the parts necessary to make my Eco Islander into the model with the light assembly above? Thanks--KEVIN
_________________________
Everything Cities Service
Specializing in old Gas Pumps
kwfrith@gondtc.com
Cell#-701-739-6133

Top
#503180 - Sun Jan 05 2014 08:06 PM Re: ECO light assembly [Re: K W FRITH]
K W FRITH Offline
Veteran Member

Registered: Sun Oct 21 2007
Loc: Devils Lake, ND---USA
I think I've found a top casting and I would like to find an original gooseneck part too!
I've been told that the repro parts work very well and I may have to go that way, but I would really like to find original parts if possible??
_________________________
Everything Cities Service
Specializing in old Gas Pumps
kwfrith@gondtc.com
Cell#-701-739-6133

Top
#503256 - Mon Jan 06 2014 04:09 AM Re: ECO light assembly [Re: K W FRITH]
Jack Sim Offline
Veteran Member

Registered: Fri Nov 10 2000
Loc: St. Louis, MO, USA
Originally reproduced by Mike Wald of Des Moines. He made both pieces. He quit making them about the time Ron Scobie started masking them. Ron still shows one of the pieces on his website.

Mike has mentioned many times that he might make them again, but I doubt he will, not worth the time and investment, they require a lot of work the way he made them. His were ready to install when you got them.

Jack Sim
_________________________
Author, Gas Pump Identfication books 1st & 2nd Editions & Air Meter Identification books
We rebuild ECO air meters and sell parts.

Top
#503444 - Mon Jan 06 2014 09:28 PM Re: ECO light assembly [Re: Jack Sim]
Dick Bennett Offline
Veteran Member

Registered: Wed Oct 25 2000
Loc: Santa Paula, Calif
Originally Posted By: Jack Sim
Originally reproduced by Mike Wald of Des Moines. He made both pieces.

Mike has mentioned many times that he might make them again, but I doubt he will, not worth the time and investment, they require a lot of work the way he made them. His were ready to install when you got them.

Jack Sim

It was Mike Wahl of Norwalk,Iowa. Fully Machined & tapped.
_________________________
Reproduction/Fantasy Cans
http://i124.photobucket.com/albums/p2/oldegaspump/AllCansMASTERTHUMBNAIL_zps4bfdbbc7.jpg
Rnd Can Re-lids


Top

Moderator:  Oldgas, Ryan Underthun, Watchdog2 

Click on magnifying glass icon on lower left to search eBay

Copyright © 2016 Primarily Petroliana Interactive, All Rights Reserved