|
#568393
Sun Sep 14 2014 07:31 PM
|
Joined: Dec 2010
Posts: 635
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Dec 2010
Posts: 635 |
Selling my original Wayne40A. I installed the correct 8" veeder root which was missing as well as one of the face bezels. The bottom 90 degree brackets were rough so I had new ones fabricated. I also have the base. Asking $1600. Thanks.
|
|
|
These topics are archived because they are older. You may not post new replies. Contact member through their email in their Profile or by PM message. Help with contacting members
|
|
|
Joined: Dec 2002
Posts: 3,188 Likes: 1
Veteran Member
|
Veteran Member
Joined: Dec 2002
Posts: 3,188 Likes: 1 |
|
|
|
|
Joined: Dec 2008
Posts: 1,192
Veteran Member
|
Veteran Member
Joined: Dec 2008
Posts: 1,192 |
Great deal on that pump! Good luck on the sale. Should go quick!
|
|
|
|
Joined: Sep 2007
Posts: 19,463 Likes: 1016
Veteran Member
|
Veteran Member
Joined: Sep 2007
Posts: 19,463 Likes: 1016 |
nice looking pump & reasonably priced but your a few miles away...
RANDY
|
|
|
|
Joined: May 2012
Posts: 4,293 Likes: 27
Veteran Member
|
Veteran Member
Joined: May 2012
Posts: 4,293 Likes: 27 |
I agree! Unfortunately a little ways away. Great pump by the way!
Braden Splichal
|
|
|
|
Joined: Dec 2011
Posts: 8,818 Likes: 2
Veteran Member
|
Veteran Member
Joined: Dec 2011
Posts: 8,818 Likes: 2 |
Somebody did nice work fabricating those lower pieces for the rails.
Dave GILL, Dave's Garage & Memorabilia, Inc.
|
|
|
|
Joined: Dec 2010
Posts: 635
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Dec 2010
Posts: 635 |
Sold pending payment. Thank you for the interest.
|
|
|
|
Joined: Jul 2001
Posts: 4,005 Likes: 7
Veteran Member
|
Veteran Member
Joined: Jul 2001
Posts: 4,005 Likes: 7 |
Thanks, Phil _________________________________________________ Looking for any old pumps, or nice 5 gallon cans.
|
|
|
|
Joined: Mar 2002
Posts: 2,313 Likes: 86
Veteran Member
|
Veteran Member
Joined: Mar 2002
Posts: 2,313 Likes: 86 |
Somebody did nice work fabricating those lower pieces for the rails. I agree those lower pieces looked stamped out. Very professional work. Rob
|
|
|
|
Joined: Dec 2005
Posts: 418
Petro Enthusiast
|
Petro Enthusiast
Joined: Dec 2005
Posts: 418 |
I would like to get some of those made for Wayne 60 rails
|
|
|
|
|
|