I bought and then sold a coke machine last year, and these lids and panels were stacked inside. I’m tired of tripping over them, and would like to sell them. My problem is that I have zero idea what specific coolers/machines these parts belong to. I’ve numbered them in the photo, and below I will give rough measurements in inches for each piece. Any help from the folks that know a lot more about soda machines than I do would be much appreciated. thanks Paul 1-24 x 8¾ 2-28 x 15¼ 3-30 x 11¾ this lid has led a hard life. Looks to have been a favorite landing spot for a lot of rear ends. 4-28 x 12½ 5-12¾ x 10 6-29 7/8 x 12
Appear to be from a large Westinghouse/Cavalier chest cooler, WD-20, WD-22, C-20, C22... #1 is definitely the center panel between lids on a large cooler
That was exactly what I was hoping for, thank you. When I first posted this thread, JimT suggested I might get some help from the link in your sig block, soda-machines.com. I submitted my registration, but sadly I have yet to hear back from them and be approved. Thanks very much for the assist. Paul