Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion Another Wayne 70 restoration question

I don't intend to annoy anyone, but as I get deeper and deeper into my project, I will have questions from time to time, as I have never done a Wayne pump, so here goes the next question...I have seen the Honest Measure button for sale for Wayne 70's, however I can't find one on mine. Where does is it supposed to be located?

Not all 70's had them.
But the ones I have found that did, were on the sides of the pump [above the reset crank & below the hose outlet on tall 70's]. In line with the computer.
db

Not to be contrary to Dick, because he knows a he** of a lot more than me. But the two Wayne 70s I found had the tags on each side and below the reset crank about equal heighth to the pump plate on the front. But, I would defer to Dick's opinion

Alex,
Even I make MISTAKES, NO ONE knows all the answers. There are just too many combonations that the differant pump companys used.
Maybe they were doing it the way the designer had drawn the pump. A forman walks by, an says "I think it would look better if we move this item to here".
OR, maybe the pumps you found were the Fort Wayne's & mine were the San Francisco Division !

NO HARD FEELINGS here.
db

Thanks guys, this will help!