I am looking for ideas on how to get a cast iron pump part produced if I can't find a replacement. So far no luck.
I need a nozzle holder for a Milwaukee visible pump. It has one but it is broken at the bottom.
Ron can't supply one.
Anyone know anybody that can cast one or repair the one I have?
Thanks
Email: john@oldgaspumpguys.com

Have had to recast many parts and the first thing you need is to make it so that you can either recast or repair. Do you have either a picture or another one to recast off of ?

Thanks Craig no I don't have another one to work with.
I have had a lot of Milwaukee pumps over the years and I have never seen a nozzle receiver broken like this.

John, I use an Amish Family in Pa. Cattail Foundry, 167 W. Cattail Rd. Gordonville, PA. 17529 phone 717 768-7323. I think that they have the ability to make a wooden pattern from your original....making it whole again? By using your original as a piece to copy. They can then recast it in cast iron or aluminum. It has been a while since I was there but it is a family concern and as the Amish do, it will survive as the younger generation takes over. Mr. King is the gentleman I worked with. Paul www.severngaspumps.com

if you take it off and sandblast it and send it to me,i will have it welded.using mine as a pattern.here are pics of mine.charley

Charlie thank you very much I can do.that.
It might be a few weeks since we just got a monster snowstorm last night and the pump is outside.
Thank you and I will be in touch.

Charlie it is going out today.