|
#9189
Wed Aug 15 2007 01:07 PM
|
Joined: Aug 2006
Posts: 892
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Aug 2006
Posts: 892 |
I bought a Tok 850 square today and have some questions. I did a search and got some information but I need more. The pump is in very good condition, someone has restored it in the past and it needs to be redone. The visi appears to be acrylic, the, what I call the collar, is stamped metal. Did they come metal and cast? The clock faces are in good condition and there is a shut off, knob, below the faces. The pump is gone and I believe the base is cast aluminum, was this original? Thanks.
Mick
|
|
|
Please - NO offers to Buy or Sell in this forum category
Statements such as, "I'm thinking about selling this." are considered an offer to sell.
|
|
#9190
Wed Aug 15 2007 01:30 PM
|
Joined: Dec 2000
Posts: 1,730 Likes: 19
Veteran Member
|
Veteran Member
Joined: Dec 2000
Posts: 1,730 Likes: 19 |
Mick, The top of the visi is stamped steel attached with a single round head slotted machine screw to a cast iron top plate. There should be an interior glass cylinder with a spinner assembly and of course an exterior glass cylinder. The base of the pump should be cast iron. Ron Parts at - http://www.gaspump.com/Other_Parts.html
|
|
|
#9191
Wed Aug 15 2007 02:58 PM
|
Joined: Dec 2006
Posts: 3,369 Likes: 7
Veteran Member
|
Veteran Member
Joined: Dec 2006
Posts: 3,369 Likes: 7 |
I had one that had 950-A plates over the 850 on the faces, square body and had a short visi unit with a curved paddle wheel inside. Flat cast top, cast bottom,aluminum paddle wheel, only one glass
Veeder Root Rebuilds.....since 1987 Veeder Root Identification CD Gas Pump Clock Repair jkyocom@bellsouth.net
|
|
|
#9192
Wed Aug 15 2007 04:11 PM
|
Joined: Jul 2002
Posts: 740
Petro Enthusiast
|
Petro Enthusiast
Joined: Jul 2002
Posts: 740 |
Hi Mick; I have 2 square 850's one cast one stamped steel. the gas pump blue book dates the stamped steel collar made in 1933 the cast collar 1931-32 according to the serial #s on my pumps, so yes they made both. all visi-guages on my 4 850's are all the same, 2 sq. 2 round. never seen a stamped steel round yet but it's probably possible. congrats on a great pump. ;;;;;;;;;;;Ron
|
|
|
#9193
Wed Aug 15 2007 05:03 PM
|
Joined: Oct 2000
Posts: 22,780 Likes: 5
Veteran Member
|
Veteran Member
Joined: Oct 2000
Posts: 22,780 Likes: 5 |
I have a Square 850 also. I think you are asking about the Center piece [between the head unit & lower sheet metal]. ALL I have seen, that piece is Stamped steel [I also have a round 850 with the stamped steel, West Coast mfg.].
The knob below the face is to Reset the clock mech. db
|
|
|
|
|
|