Brian, you might call Andy at Gas Pump Heaven or Seth at Vics and check the top and bottom measurements with them. Could be you could take the solid panel repo skins they sell and cut them to fit with your waistline style pump. Might have to add a couple of latches depending on where that casting falls.

Might also take original panels (if you have them) to a sheetmetal shop and ask them to duplicate them. I've had that done on a couple of 870's and they turned out nicely. They used a plasma cutter to make the face and other cut outs. I reattached the original latches.

Hope you will post a picture of this when you get it completed!! Thanks and good luck.

[This message has been edited by Morgan (edited 05-22-2001).]