My Red Sentry is missing a simple piece that appears to be part of the approved calibration.
This is a simple sheet metal bent tab piece, to the left of the pump arm pivot, connected to the stop "peg" for one gallon.
Also looks to be a fillister head machine screw, holding this tab piece, drilled for being "lead sealed" to this tab.

I need someone to take this piece off and photo, to allow me to fabricate one for my pump please.
Also a close up of the 10-24, straight slot, drilled fillister head?

Thank you
Craig

Cut245RedSentryMissingPiece1.JPG Cut245RedSentryMissingPiece2.JPG Cut245RedSentryMissingPiece3.JPG
Last edited by tokig; Fri Dec 22 2017 01:50 PM.