Just picked up what I believe to be a 665. The faces are exactly like the common GB clock face that there are repops of but these measure 11" round exactly instead of 10". I am in need of a set of faces and the clock hands pictured below. Would prefer original but will consider anything. Also need one round face bezel and a cast iron base. If anyone has this pump please pm me I have a few questions. Thanks

I had this one but sold it a few months back. Cool pump and not often seen. Mine had different hands. I may have an extra set of faces but I'd really have to dig. If no one else chimes in let me know.

Attached are photos of my 665 and 65 side by side. I also took a close up of the 665's face and hands.

Don't know why the second photo did show but hopefully it will this time.

Thanks so much for the photos guys. Marshall, does it appear the base for the 65 is the same diameter of the 665. That would be great if it's the same base.

Here are a couple pictures of my 665 with the sheet metal off. The pump is unmolested and did not appear to have come with the typical "full" base. I haven't taken the sheet metal off the 65 yet, but if memory serves me right it is at least similar. The sheet metal on the bottom of both pumps seems to have the same diameter.

Feel free to call my cell {(585) 857-6746 and we can discuss further.

Thanks,

Marshall

Wow thats what mine looks like! I just assumed that the skins would never sit on the ground? Does anyone else have a 665 that they can confirm there was no cast iron base that attached to this bottom pictured. That'd be great if Im not missing the base..lol

Marshall's is missing the base. It's a very short cast base. You
Can make it out in the picture I posted.

Eric,

Attached are three photos of the middle band you requested. The band is 10" tall and composed of three parts. The center part has two hinges on each side and is 15 and 3/8" long. the two wings are 22 and 1/2 " long. There is a 1 and 1/2" lip around the bottom that fits over the lower sheet metal as well as a 1 and 1/2" lip that runs vertical where the two wing sections overlap. The lower lip also has a second lip that is 3 and 1/2" long that fits over the lower sheet metals two overlapping sections. Hopefully the pictures and dimensions fit together.

Get back to me if you need anything else.

Marshall thanks so much for the pictures & dimensions. Surely something I can work with to get the mid section made.