|
|
#46413
Tue Nov 28 2006 06:34 AM
|
Joined: Feb 2004
Posts: 782 Likes: 2
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Feb 2004
Posts: 782 Likes: 2 |
I have discovered the Eco 97 I am restoring has a light in the top. However the wire has been removed at the base where the light screws in. I'm not sure how the wire rans out of the unit? Did they just plug in to a wall outlet?
|
|
|
Please - NO offers to Buy or Sell in this forum category
Statements such as, "I'm thinking about selling this." are considered an offer to sell.
|
|
#46414
Tue Nov 28 2006 06:43 AM
|
Joined: May 2005
Posts: 4,643 Likes: 42
Veteran Member
|
|
Veteran Member
Joined: May 2005
Posts: 4,643 Likes: 42 |
I believe the wiring was attached to the back of the electrical socket,then just ran down the back of the box rear panel to the base opening below where the compressor air supply plugs into it.
It was hard wired into the buildings electrical via a conduit originally,so most today attach a plug & cord for convenience.
[This message has been edited by coldpizza (edited 11-28-2006).]
Collecting Vintage Sunoco
|
|
|
#46415
Tue Nov 28 2006 12:01 PM
|
Joined: Nov 2000
Posts: 7,791 Likes: 9
Veteran Member
|
|
Veteran Member
Joined: Nov 2000
Posts: 7,791 Likes: 9 |
You said you have a 97, so we are assuning you have a wall mount, sometimes we find a 97 on a pedestal as they were interchangable. The wire just exits the back of the wall mount and goes to any 120 source of power. If you need any parts you might want to look at my website: www.crspub.com Jack Sim Author, Gas Pump Identification book and Air Meter Identification book
Author, 1st & 2nd editions of Gas Pump ID book, 3rd edition is now available at www.gaspumpbible.comAir Meter ID book also available
|
|
|
#46416
Tue Nov 28 2006 11:14 PM
|
Joined: Apr 2006
Posts: 39
Active Member
|
|
Active Member
Joined: Apr 2006
Posts: 39 |
chris: As has been mentioned. Two wires were attached to that electrical socket. They were fed down and either out the back through the wall mount or clear to the bottom of the pedastal mount and out. Then connected to a convenient 110-120ac power source via a plug-in connector or hard wired and most always switch conrolled.
The wires on yours having been previously removed for who knows whatever reason. Being it frayed from old age, broken or burned etc. For SAFETY PURPOSES foremost, also a quality restoration and as you already have everything you need including the basic light mount fixture and necessary mounting socket fixture plate. It might be a real good idea, to possibly rewire it all.
This would simply entail removing the light socket by unscrewing same. Then a quick trip to your local electrical outlet for a very common and cheap, new plate mounted light socket. Plus possibly if necessitated, a length of their recommended wire and any little incidentals desired.
No big deal! Nothing else required, special parts purchases needed or shipping expenses involved, but worth far more than the minimal investment required.
[This message has been edited by haggis (edited 11-29-2006).]
|
|
|
|
|
|
|
