Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion Gilbarco 906 door glass size

I bought 2 door glass for my Gilbarco 906 V trim from Gas pump Heaven.The ad said fit 900 series pump with V trim. The size listed is the size received.They are too wide and not tall enough.With rubber installed I estimate the size to be 11 1/8 x 12 1/16,any body else have this problem.I am going to a glass shop since I now have correct size.My question is a 906 not considered a 900 series?

I bought the same ad glass from them!! same as you it does not fit.I'm ready to see what reply's you get! Some one knows!!! Allan

There are at least 3 different sized windows for the Gilbarco 900 series pump. If you measure the opening of the window hole in your door the glass should be approx 1/4" wider and 1/4" taller than the opening.

I went to Lowes and had them cut 2 sheets of glass 11 1/8 x 12 1/8 Cost $8.00.I just finished installing them,that size fits fine.By the way Allan if you don't have an original rubber,you need to relief cut the corners.I have one and can get placement measurements if you need.Thanks Terry

I realize this is an old post but I'm a new guy with an old pump ! I did as foxlincoln suggested and got lowes glass cut to my dimensions and I'm trying to install the rubber molding around the glass to hold it in place. My glass is square with sharp corners and my molding doesn't want to work as it should.

foxlincoln mentioned "Relief cuts" but I'm not sure what he referring too and I don't have enough molding to experiment.... can someone give me some guidance ??

Im also assuming the glass/molding should be installed like this??



tia john