|
|
#58391
Wed Jun 29 2005 12:16 PM
|
Joined: Jun 2001
Posts: 238
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Jun 2001
Posts: 238 |
Anyone out there have any Tok 850 photos of all of the individual pieces. Particularly the clock mech, reset mech, face and top sheet metal and how it goes together, frame, etc. Just got one and not sure if it's all there and just how it should really look. Looked not too bad in the photos I bought it from, but now that I have it and am taking it appart, not sure just how much of it is correct.
Thanks, Jeff
|
|
|
Please - NO offers to Buy or Sell in this forum category
Statements such as, "I'm thinking about selling this." are considered an offer to sell.
|
|
#58392
Wed Jun 29 2005 08:04 PM
|
Joined: Nov 2000
Posts: 7,791 Likes: 9
Veteran Member
|
|
Veteran Member
Joined: Nov 2000
Posts: 7,791 Likes: 9 |
I have original and copies of the 850 Parts manual. Please email me.
Jack Sim
Author, Gas Pump Identification book
Author, 1st & 2nd editions of Gas Pump ID book, 3rd edition is now available at www.gaspumpbible.comAir Meter ID book also available
|
|
|
#58393
Tue Jul 05 2005 02:11 PM
|
Joined: Jun 2001
Posts: 238
Petro Enthusiast
|
|
OP
Petro Enthusiast
Joined: Jun 2001
Posts: 238 |
Bringing this up again, Can't believe someone out there does not have any good pics of Tok 850 parts or restoration photos they could share. I'm going to buy a parts book from Jack but some actual photos would be nice. Come on guys, help a brother out.
Jeff
|
|
|
#58394
Tue Jul 05 2005 06:57 PM
|
Joined: Feb 2001
Posts: 871
Petro Enthusiast
|
|
Petro Enthusiast
Joined: Feb 2001
Posts: 871 |
Sent photos of my pump, send me some photos of what you think is incorrect ? Basically you should have a top, center section, base, and pipe frame. Top and bottom skins (the top skins are not reproduced in metal) Most everything else is except different pumps vary. Mine has cast iron top, center section, and base, not stamped steel. Return cranks vary. Mine has a on/off casting identical to my Tokheim 870.
Larry
Premopetrol
[This message has been edited by PremoPetrol (edited 07-05-2005).]
larry ivy
|
|
|
#58395
Wed Jul 06 2005 01:15 PM
|
Joined: Jun 2001
Posts: 238
Petro Enthusiast
|
|
OP
Petro Enthusiast
Joined: Jun 2001
Posts: 238 |
Thanks Larry, Sent you an email with some questions and picks of my pump. Also thanks to Don Beaver for his email reply.
Jeff
|
|
|
|
|
|
|
