Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion Fry 10gal 117 questions...

Hello all,
Not educated on why or what may have been modified to my Fry pump... This pump has a 12" x 27" glass cylinder and the bottom casting appears to be two pieces and will not allow for a 13 5/8" x 22" cylinder.
With that said, I'll assume this is a conversion/adapter of some kind. My ultimate question: how difficult and costly would it be to get this pump back to original state...? Lastly, is the front panel different on this pump as it appears too small to house 10 measuring stops...
Thanks in advance for any and all input!

What you have is a Fry 17 five gallon pump with a Rush conversion. That is why you have five measuring stops. The Rush pumps took a 12 X 27 cylinder. When you remove the adapter plate you will see that it takes a 10 X 20 cylinder. The Fry 117 takes a 13 5/8 X 22 cylinder. You can get reproduction parts to convert it back to an original five gallon pump. The top casting and Dome looks like they are from a different top than a Rush. Not sure what they are off of.

Thanks for the info!
I'll have to locate another original measuring stop since the upper one has been replaced/modified... I'll assume locating original parts such as the top casting and globe cup in decent condition may be difficult...?

Your top one is a modified ten gallon stop. Your lower four are correct for five gallon. You need one more of those.