|
|
 Erie 70,71 to 91 Stainless trim (reproduction)
|
Joined: Aug 2010
Posts: 626 Likes: 6
Petro Enthusiast
|
OP
Petro Enthusiast
Joined: Aug 2010
Posts: 626 Likes: 6 |
Spent a lot of time and money to repo these 14 trim pieces made from 6061 aircraft grade aluminum. Will have to open hole in your top .228 for proper fit and adjustment.$225.00 shipped.
|
|
|
Re: Erie 70,71 to 91 Stainless trim (reproduction)
|
Joined: Oct 2012
Posts: 101
Petro Enthusiast
|
|
Petro Enthusiast
Joined: Oct 2012
Posts: 101 |
Your message box is full. I sent you an e-mail.
|
|
|
Re: Erie 70,71 to 91 Stainless trim (reproduction)
|
Joined: Aug 2004
Posts: 1,664 Likes: 17
Veteran Member
|
|
Veteran Member
Joined: Aug 2004
Posts: 1,664 Likes: 17 |
Held in by studs or adhesive?
|
|
|
Re: Erie 70,71 to 91 Stainless trim (reproduction)
|
Joined: Aug 2010
Posts: 626 Likes: 6
Petro Enthusiast
|
|
OP
Petro Enthusiast
Joined: Aug 2010
Posts: 626 Likes: 6 |
|
|
|
Re: Erie 70,71 to 91 Stainless trim (reproduction)
|
Joined: Aug 2017
Posts: 47 Likes: 1
Active Member
|
|
Active Member
Joined: Aug 2017
Posts: 47 Likes: 1 |
Can you post a picture of the back side showing the PEM nuts. Thanks, Bob
|
|
|
|
|
|
|
