Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion need help with a gilbraco 1006

This is my first pump. I am working on it but have a few questions about it. Did all of them have the stainless steel center section. Where do i find new windsheilds for it, and what exactly is the piece that is behind the glass and has the type of fuel on it, as mine is missing. And where can i find a new circular bulb for it. Thanks in advance.

I'm not a collector of later than 1940's pumps, but IF glass is flat any glass company can cut for you. I'm thinking your pump has curved glass, place a posting here in the WANTED Forum;
http://oldgas.com/forum/ubbthreads.php?ubb=postlist&Board=10&page=1
also contact tbuckles &/or The PumpDump & ask if they have any For Sale.
Good Luck
db

Here is a picture of a NOS ad glass I found on ebay a couple of years ago. They show up once in a while.
If you do not find any original glass (should be available on some rusted out pump IMO) try to use plexi glass that you cut to the approximate measures put over the pump and heat slowly with e heat gun or similar to make the curve.

I have been using white or frosted plexi glass and decals to make ad glass for pumps. Could be done for a 1006 too.
br
Claes

NOS ad glass GB 1000 series