Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion Securing doors on a Gilbarco 96. What's missing?

I have this GB 96-B that came to me in pieces. In looking through the parts it appears I'm missing some stuff and wondered how the doors secure to the frame. The lower inside door has one bracket spot welded to the door that drops over a frame horn, but there's nothing on the backside of the door itself that can secure the door to anything higher up (like midway and top)?

I must be missing a piece at the midway point that bolts to the door, and something at the top bracket that latches up high? Can anyone send me a picture so I can see what I'm missing to get these doors to mount? Thanks

Here's the frame with these brackets half way up.


I'm assuming there's a bracket similar to the bottom of the door that's supposed to bolt through the door here and drops over that latch on the frame?


There's this area in the center...does something drop down into this section and latch the door?


I have these brackets that go on the door but how do they secure the door? Or are they for some other purpose?

This is what you are missing. There are four needed per door. There is nothing that attaches at the top of the door. Hope this helps, Ryan

http://www.thepumpdump.com/parts/main.php?g2_itemId=2145

Graeme, your pictures #3 & #4 you're not missing anything.

Your picture #1 you should have 4 of those frame brackets on each side of your pump. Two at midpoint and 2 at the bottom of the door opening.

The door latch brackets in your picture #3 that you are missing; you need four for each door, 2 lefts & 2 rights.

I've attached photo's for your reference.

Again Dave you come through with the close ups for help, Thanks again for helping me.

Thank you for the info guys, and big thanks for the pictures Dave. Now for my next question...anybody got 2 sets for the middle of the doors. Two lefts and 2 right. If not I will make them.

You're welcome. Glad, I was able to help.