ggpuck123 & ynot
I believe I made a mistake on the nail clips...went down and looked at the trim on the 966 and the flat steel part is what fits in the chanel of the trim and the nail is attached to the flat steel clip. The nail protrudes through the window rubber, and the rubber is stiff enough to keep it from pulling back through.The nail head sticks out the back side about a 1/16". Make sure when you poke the nail head into the rubber you don't hit the glass itself.
Sorry for the misleading info I gave last night...I was going from memory and that is not a good thing for me to do. Must have been hardening of the cranium (duh).
Good luck on the glass install.The Bennett 966's are a real PITA. I have heard that some repop rubber channel is extremely tight on original glass. I used original glass with original rubber on one side and aftermarket glass and rubber on the other door.I left the addglass and stainless trim off the backside since it is against the wall and can't be seen. I don't recall there being a noticeable difference in size but heard there might be a slight difference in the glass thickness...maybe someone else with more glass experiance can jump in and shed some light on this subject.
Kurt
[This message has been edited by K F H (edited 11-04-2008).]
