Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums General Petroliana Discussion Where does this go?? Bennett 766 part

Sounds almost like a good deal!! Lol

OK OK, How many MB's do you want for it?

I was going to suggest you buy a 766 Parts Manual from me, but I decided to look at the manual to see if I could spot the part.

It's not there, not even on the 756.

Jack Sim

Dan, do you see the two center bars going across and attaching to the upright pump frame bars. Just below the computer. You will note that there is a latch assembly attached to the cross bar. In the picture you can see the front view and the rear view of the bar. If you look at the back of the door in the center is a brace that goes across and is placed at the same height as the cross bar on the pump frame. There is a slot in the door brace that accepts the latch from the cross bar. If you turn the latch from the back side and line up the latch so that it will fit into the slot in the brace as you are closing the door. Once the latch fits into the slot turn the lever further and it will lock the door in the closed position. Hope the foregoing makes sense.

Maybe this will help the Newbie from Cincinnati!
Just wait till they start Multiplying! LOL

. That's sure what it looks like ,the square is where the detent cable snaps into for a 350 turbo automatic trans.

Its for throttle cable.. the ones for the detent cable have 2 hole.

Thanks guys. I think I understand this now. Thought is was more complicated than it is. Thank Dave and DB for the good photo
Dan

Almost got it done. Just have to get a few more tiny parts to get ( door hinge, hose and weather strips and eventually a power x globe)

This has been fun for sure can't wait till the next one.

The nice thing about this pump was that it was a sinclair pump from the start. All original parts are on it minus the globe, which it only had a cover over the hole. The pump was in great shape to start with. The veeder still ran and the frame and bottom were very clean.

Another Reason to Never Give Up. Very nice job Dan & Especially since your not the one who Took it Apart!

ps; light switch shouldn't stick-out like a sore thumb!

Did you find a Power X globe for it? I have a very nice one.

Looks good!

Take off the knob off of the light switch actuating rod. There should be no knob on it. The end of it has a knurled finish that simply protrudes through a black rubber grommet.

Dave,
It appears it has been changed; Push/Pull switch.
1st finished pic is w/ lights on & knob is closer to body,
in 2nd pic lights are off & knob is further away from body.

Wow, you are very observant DB. You're right original switch would be on when pulled out and off when pushed in.

Looks great!love them Dino's!