Primarily Petroliana Shop Talk Forums Shop Talk Petroliana Forums Want to Buy Petroliana Wanted: Veeder root instruction sticker

Hello All, As usual I have my hand out begging for help.
I need a Veeder root instruction sticker for the Bowser 595 that I have. I got it all cleaned up and just need the instructions on it.

Thank you

There is progress underway to get some of these made, but as of this moment none are available that we know of. Read this thread for the whole story:

http://www.oldgas.com/forum/ubbthreads.php?ubb=showflat&Number=587874#Post587874

Pm me your address and I will send you one. Dick Bennett made them and he gave me some extra's so I'll pass it on. As Gary said they are in the works thanks to Jim, T-Way Graphics.
Tom.

Tom (and everybody)

I received the package (from Tom) with ALL the images DB used to produce.

It will take me a bit of time to recreate all of them in my system.

Once everything is ready, I'll add a spot on the 'U - V' page in our decal section that will open up to a full page showing all of these decals with code numbers for ordering.

This might take a week or two depending on how much other work I have going, so please bear with me.

Thanks!

Jim
T-way's Graphics
Toll Free: 866.546.4067

Glad to hear you're going to add those to your line Jim. I'm sure a lot of folks will be ordering them. Thanks to Tom also for supply of the decals. You know, I was just thinking about the decals yesterday when I was finishing up this pump and the computer didn't have a new decal on it. It's a shame that we work for hours to rebuild the VR back to life, all shiny and bright (with a new decal if we had one) and then it's closed up inside the pump and nobody ever sees it again unless they open the pump! Sometimes I wonder about our affliction .........GB

I'm slowly working my way through replicating all the VR decals DB used to make. I'm fixing the spelling errors and some other minor mistakes too! LOL

But I need some help from the petro community.

does any one have good reference of the Veeder-Root logo as shown below. The art on DB's decals is kind sketchy and I would really like to make it clean and correct.

If you can provide a nice high-resolution scan of a better image, please send it via e-mail to: T-ways@email.com

Thanks!

Jim

The Veeder-Root restoration decals are finally finished and available.

You can access the dedicated page here: http://www.t-waysgraphics.com/decalsUV.htm

Pricing is shown at the top of the page. Please use the Number codes (#) when you place your order.

Thanks for your patience. It took longer than I anticipated to recreate these guys.

Later . . .

Jim