Can you get a better picture of the bottom cylinder plate from above and the area immediately below as indicated by my arrow. I'm still curious about this pump. Two photos showing the complete pump from opposite sides would also be helpful
1. There appears to be some opening with possible lever below the bottom plate.It may be an optical illusion because of the poor photo quality.
2. The base plate appears to have a straight side, the Bennett 810 is sloped.
3. The skins appear to have a cover strip to hide the seam. The 810 has 4 matching flanges on each side through which a bolt is placed to tighten the skins together.
4. Gallon Indicators are Boyle Dayton however they could have been easily switched out.
5. When seen from the side the Bennett 810 bottom cylinder plate appears rather thin. Yours look to thick to be a Bennett 810
6. The nozzle kook is not for a Bennett 810.See photo.
Last edited by Tim Rohr; Sat Feb 07 2015 03:30 PM.
